Detection of a single-charge defect in a metal-oxide-semiconductor structure using vertically coupled Al and Si single-electron transistors

An Al-AlO_x-Al single-electron transistor (SET) acting as the gate of a narrow (~ 100 nm) metal-oxide-semiconductor field-effect transistor (MOSFET) can induce a vertically aligned Si SET at the Si/SiO_2 interface near the MOSFET channel conductance threshold. By using such a vertically coupled Al and Si SET system, we have detected a single-charge defect which is tunnel-coupled to the Si SET. By solving a simple electrostatic model, the fractions of each coupling capacitance associated with the defect are extracted. The results reveal that the defect is not a large puddle or metal island, but its size is rather small, corresponding to a sphere with a radius less than 1 nm. The small size of the defect suggests it is most likely a single-charge trap at the Si/SiO_2 interface. Based on the ratios of the coupling capacitances, the interface trap is estimated to be about 20 nm away from the Si SET.Comment: 5 pages and 5 figure

A planar Al-Si Schottky Barrier MOSFET operated at cryogenic temperatures

Schottky Barrier (SB)-MOSFET technology offers intriguing possibilities for cryogenic nano-scale devices, such as Si quantum devices and superconducting devices. We present experimental results on a novel device architecture where the gate electrode is self-aligned with the device channel and overlaps the source and drain electrodes. This facilitates a sub-5 nm gap between the source/drain and channel, and no spacers are required. At cryogenic temperatures, such devices function as p-MOS Tunnel FETs, as determined by the Schottky barrier at the Al-Si interface, and as a further advantage, fabrication processes are compatible with both CMOS and superconducting logic technology.Comment: 6 pages, 4 figures, minor changes from the previous version

Local conductivity and the role of vacancies around twin walls of (001)-BiFeO3 thin films

BiFeO3 thin films epitaxially grown on SrRuO3-buffered (001)-oriented SrTiO3 substrates show orthogonal bundles of twin domains, each of which contains parallel and periodic 71o domain walls. A smaller amount of 109o domain walls are also present at the boundaries between two adjacent bundles. All as-grown twin walls display enhanced conductivity with respect to the domains during local probe measurements, due to the selective lowering of the Schottky barrier between the film and the AFM tip (see S. Farokhipoor and B. Noheda, Phys. Rev. Lett. 107, 127601 (2011)). In this paper we further discuss these results and show why other conduction mechanisms are discarded. In addition we show the crucial role that oxygen vacancies play in determining the amount of conduction at the walls. This prompts us to propose that the oxygen vacancies migrating to the walls locally lower the Schottky barrier. This mechanism would then be less efficient in non-ferroelastic domain walls where one expects no strain gradients around the walls and thus (assuming that walls are not charged) no driving force for accumulation of defects

Energy and momentum relaxation dynamics of hot holes in modulation doped GaInNAs/GaAs quantum wells

We present the studies of energy and momentum relaxation dynamics of nonequilibrium holes in GaxIn1−xNyAs1−y/GaAs quantum well modulation doped with Be. Experimental results show that the real-space transfer (RST) of hot holes occurs via thermionic emission from the high-mobility GaInNAs quantum wells into the low-mobility GaAs barriers at a threshold electric field of F ∼ 6 kV/cm at T = 13 K. At this field the hole drift velocity saturates at vd ∼ 1×107 cm/s. A slight increase in the field above the threshold leads to the impact ionization of acceptors in the barriers by the nonequilibrium holes. We observe and model theoretically a negative differential mobility effect induced by RST that occurs at an electric field of F ∼ 7 kV/cm. The observed current surge at electric fields above 7 kV/cm is attributed to the hole multiplication induced by shallow impurity breakdown in the GaAs barrier and impact ionization in the high-field domain regime associated with the packet of RST of holes in the well

Electronic Interface Reconstruction at Polar-Nonpolar Mott Insulator Heterojunctions

We report on a theoretical study of the electronic interface reconstruction (EIR) induced by polarity discontinuity at a heterojunction between a polar and a nonpolar Mott insulators, and of the two-dimensional strongly-correlated electron systems (2DSCESs) which accompany the reconstruction. We derive an expression for the minimum number of polar layers required to drive the EIR, and discuss key parameters of the heterojunction system which control 2DSCES properties. The role of strong correlations in enhancing confinement at the interface is emphasized.Comment: 7 pages, 6 figures, some typos correcte

Nanostructured electrodes for thermionic and thermo-tunneling devices

Recently, new quantum features have been studied in the area of ridged quantum wells (RQW). Periodic ridges on the surface of the quantum well layer impose additional boundary conditions on the electron wave function and reduce the quantum state density. Electrons, rejected from forbidden quantum states, have to occupy the states with higher energy. As a result, Fermi energy in RQW increases and work function (WF) decreases. We investigate low WF electrode, com-posed from a metal RQW layer and a base substrate. The substrate material was selected so that electrons were confined to the RQW. The WF value depends on ridge geometry and electron confinement. We calculate WF in the metal RQW films grown both on a semiconductor and metal substrates. In the case of semiconductor substrate, wide band gap materials are preferable as they allow more reduction in RQW work function. In the case of metal substrate, low Fermi energy materials are preferable. For most material pairs, the WF was reduced dramatically. Such structures, can serve as electrodes for room temperature thermionic and thermotunnel energy converters and coolers.Comment: 8 pages, 5 figures, 2 table

Heterostructure unipolar spin transistors

We extend the analogy between charge-based bipolar semiconductor electronics and spin-based unipolar electronics by considering unipolar spin transistors with different equilibrium spin splittings in the emitter, base, and collector. The current of base majority spin electrons to the collector limits the performance of ``homojunction'' unipolar spin transistors, in which the emitter, base, and collector all are made from the same magnetic material. This current is very similar in origin to the current of base majority carriers to the emitter in homojunction bipolar junction transistors. The current in bipolar junction transistors can be reduced or nearly eliminated through the use of a wide band gap emitter. We find that the choice of a collector material with a larger equilibrium spin splitting than the base will similarly improve the device performance of a unipolar spin transistor. We also find that a graded variation in the base spin splitting introduces an effective drift field that accelerates minority carriers through the base towards the collector.Comment: 9 pages, 2 figure

Charge state of the O2_{2} molecule during silicon oxidation through hybrid functional calculations

We study the charge state of the diffusing O$_2$ molecule during silicon oxidation through hybrid functional calculations. We calculate charge transition levels of O$_2$ in bulk SiO$_2$ and use theoretical band offsets to align these levels with respect to the Si band edges. To overcome the band-gap problem of semilocal density fuctionals, we employ hybrid functionals with both predefined and empirically adjusted mixing coefficients. We find that the charge transition level $\epsilon^{0/-}$ in bulk SiO$_2$ occurs at $\sim$1.1 eV above the silicon conduction band edge, implying that the O$_2$ molecule diffuses through the oxide in the neutral charge state. While interfacial effects concur to lower the charge transition level, our estimates suggest that the neutral charge state persists until silicon oxidation.Comment: 4 pages, 3 figure

The Contribution of Hot Electron Spin Polarization to the Magnetotransport in a Spin-Valve Transistor at Finite Temperatures

The effect of spin mixing due to thermal spin waves and temperature dependence of hot electron spin polarization to the collector current in a spin-valve transistor has been theoretically explored. We calculate the collector current as well as the temperature dependence of magnetocurrent at finite temperatures to investigate the relative importance of spin mixing and hot electron spin polarization. In this study the inelastic scattering events in ferromagnetic layers have been taken into account to explore our interests. The theoretical calculations suggest that the temperature dependence of hot electron spin polarization has substantial contribution to the magnetotransport in the spin-valve transistor.Comment: 8 pages and 6 figure

Shockley-Ramo theorem and long-range photocurrent response in gapless materials

Scanning photocurrent maps of gapless materials, such as graphene, often exhibit complex patterns of hot spots positioned far from current-collecting contacts. We develop a general framework that helps to explain the unusual features of the observed patterns, such as the directional effect and the global character of photoresponse. We show that such a response is captured by a simple Shockley-Ramo-type approach. We examine specific examples and show that the photoresponse patterns can serve as a powerful tool to extract information about symmetry breaking, inhomogeneity, chirality, and other local characteristics of the system.Comment: 7 pgs, 3 fg